![]() If this doesn’t happen it could be because the unit needs to be setup. Let’s hope the power light eventually stops blinking within a few minutes., and the Wi-Fi light comes on. ![]() Get a paper clip you can use to press in the reset button (you can feel a slight click) hold in for 2-3 seconds and then release button. Look near lower right corner for a red button in one of the holes. It is on broad side opposite the signal strength lights. ![]() I suggest you set up the 2.4G signal first and get close to where your router is not less than 5-10 feet away. Set the back switch to 2.4G while unit is off. I have a few of these, I set a few up for others, and they all work fine, So, maybe you need to press the reset button and start over.
0 Comments
Leave a Reply. |